🔥 All are ready stock in Sungai besi office & ship within 24 hours* (Except for public holiday, but do call us to check)
[New Arrival] ABS+
Less Warping, can use on Acetone!
(Tested on Smith3D ABS)
Recommendations for a Successful ABS Printing:
– Heat plate should be always on (between 80 – 100C)
– You may turn On Brim, improve adhesion on the first layer.
ABS no.1 enemy is warping, to avoid that:
– Turn Off Part Cooling Fan
– Hot printing environment (No fan or Air conditioner)
– Enclosure for bigger prints
Warping normally occurs in the middle of your printed model when the heat can’t reach from the bottom (bed) and from the top (nozzle). For tall or big prints, it’s almost vital to make an enclosure to trap heat at area around the model so it doesn’t shrink and warp.
akmalnorisham01 –
[Variation: Green]
kingsdomsky –
[Variation: ABS+ Red]
izuka.arts –
[Variation: ABS+ White]
issey83 –
[Variation: ABS+ Gray]
baemtorettoo –
[Variation: ABS+ Gray]
n*****n –
[ABS+ White]
thomastansr16 –
[ABS+ Red]
n*****9 –
[ABS+ Black]
rosliahmadawang –
[ABS+ Black]
t*****7 –
[ABS+ Black]
fieda5229 –
[ABS+ Black] Excellent, warranty part also received. Recommended seller.
nazuq74 –
[ABS+ Black]
h*****n –
[ABS+ Pink]
seriouslyadditivemanufacturing –
[ABS+ Blue] Good product quality and value for money. Good packaging and fast delivery.
ken09253me –
Quick delivery good quality quick delivery good quality quick delivery good quality [Variation: ABS+ White]
e*****l –
[Variation: ABS+ Black]
rahmanuddeenroslan –
[Variation: ABS+ Black]
leongbiggrey –
[Variation: Red]
leongbiggrey –
[Variation: ABS+ Gold]
w*****w –
Don’t know if it is a bad batch but filament was popping a lot probably due to moisture. Don’t think I can recommend it. [Variation: ABS+ Black]
wmkdesign –
[Variation: Red]
wmkdesign –
[Variation: ABS+ White]
wmkdesign –
[Variation: ABS+ Black]
amarrex857 –
[Variation: ABS+ Gray]