[New Arrival] Bigtreetech SKR E3 TURBO 32 Bit 3D Printer Controller for Ender 3 Series

Take note that this is the December 2020 Batch, the batch after BTT tested the Temperature fluctuation issue.

Installation & Full Review: https://www.makenprint.uk/3d-printing/3d-printing-guides/3d-printer-mainboard-installation-guides/skr-e3-turbo-setup-guides/skr-e3-turbo-setup-guide/

1.【SKR E3 Turbo Equivalent to】: SKR V1.4 Turbo with 5pcs TMC2209
2.【Power Chip】：Use SGM6130 power chip, support 12-24V power input, power conversion rate up to 94%, maximum output current up to 2.5A;
3.【Function】：Onboard Sensorless homing function, which can be used by plugging in the jump cap；
4.【Support】：Support BLtouch, filament detection, power-off resume, automatic shutdown, etc
5.【Standby function of TMC2209】：Adding the Standby function of TMC2209, customers can change the firmware according to their personal needs,Set the Standby function. In this mode, the drive chip will automatically cut off the power supply to the motor.Its own power consumption will also be reduced to a minimum, effectively reducing printer power consumption and saving power consumption;