[New Improved] Crystal Clear UV Photosensitive Resin 1KG for LCD 3D Printer Added Fluorescent Agent

Crystal Clear UV resin that won’t easily turn yellow after post curing. To get water like transparency, do apply a layer of clear coat spray, not too much though 🙂

Over 100+ formula testing, finally this is the best fore retaining the anti-yellowing agent.

This resin added Fluorescent agent to make it easier to print, and most importantly harder to produce “skin” or residue during curing. which happens very frequent on transparent type of resin.

Compatible with RBG & also mono printer.

Do not over cure it, sometimes it may be yellowish but it will turn transparent again after a while.

[Mono Screen]
Exposure Time: 6-9s
Bottom Layer Exposure Time: 80s

[RBG Screen]
Exposure Time: 15s
Bottom Layer Exposure Time: 120s

[Specification]
UV Wavelength: 355~405nm
Shore Hardness: 85D
Density: 1.13g/cm3
Bending Strength: 70-80Mpa
Viscosity: 500-600Mpa
Elongation:30-50%
Shrinkage Rate: 1-4%
Smell: No smell