Description
Notes: As the filament contains powders, you might want to reduce the chances of clogging by increasing the nozzle size to 0.6 and above. 0.4 has chance of clogging. Abrasive filament best equip with hardened steel to prevent the hole getting bigger.
If you are using older nozzle, do cold-pulls. Or Just a lot of hot-pulls. They really work! Step 1. Heat up to around 180C, Step 2. Jam down a filament, push it so that it starts to get soft/melt. Pull it up and see all the gunk it brings. Step 3. cut of the dirty 1-2Cm and repeat until clean. This almost fixes any clogs!
Specifications:
Diameter: 1.75MM
Tolerance Level: ±0.02MM
Print Temperature: 190-220°C
Print Speed: 40-60mm/s
Cooling fan: ON
Base Plate Temperature:25-60°C
Recommended Storage Temperature : -20 to 50°C
Tensile Strength: more or equal to 60MPa
Flexural Strength: more or equal to 60MPa
Flexural Modulus : more or equal to 2500MPa
Impact Strength (IZOD, 23C) : more or equal to 3KJ/m (ASTM D256)
Elongation at Break: more or equal to 3%
Distortion Temp.: more or equal than 55C
Recommended Storage Temperature : -20 to 50C
wejust3cm –
[Variation: Galaxy Matte Black]
s*****a –
Great seller to deal with, pleasant experience overall. 11/10 would deal again [Variation: Galaxy Matte Black]
david1717septario –
[Variation: Galaxy Blue]
azzaahmad07 –
[Variation: Galaxy Matte Black]
3cmlab –
Best Service, good price ! Ans fast delivery…
Recieved after 10 mins after make the payment. [Variation: Galaxy Matte Black]
3cmlab –
[Variation: Galaxy Matte Black]