Polycarbonate filament is a great 3D material because of it’s strength
A really strong material while still maintaining temperature resistance
Extruding temperature is generally around 260 C depending on the printer.
PC slowly softens when heated, Slower print speeds are preferred as an increase in temperature is required for faster prints.
Guando Build Sheet should be used on a heated bed.
Bed printing temperature: 100-120C
Bed adhesion: Glue stick, hair spray, cyanoacrylate, Kapton tape, ABS slurry, commercial solutions
Printer enclosure: Recommended (sometimes required)
All-metal hot end: Required
Please do not inhale any fumes. Heated up superglue can release toxic fumes, so only use in a well ventilated area.
It is a hygroscopic material, it is best to store in an airtight container when not in use
Material: PC Filament
Filament Diameter: 1.75mm
Print Temperature: 250~280℃
Infill Speed: 20-50mm/s
Heat-Bed Temperature: >110℃
Net Weight: 1KG
Gross Weight: 1.32KG
Izod Impact Strength Test: 700J/m
Heat Deflection Temperature: >= 120C
Prints well on Ender 5 at 260C and 100C