[New Optimized] Engineering Resin High Temp Series 1KG 1000g High Toughness 150C

If you need a resin with advanced functionality, resistance to stress & stability over time, here’s it the High Temp Series!

Print with Mono LCD:
Base Exposure: 60~80s
Normal Exposure: 3~5s

Print with RGB LCD:
Base Exposure: 80~120s
Normal Exposure: 8~12s

NOTE: The exposure time should be adjusted according to printer light energy, layer height and model structure.

Specification:
Mode: SM3D815
Withstand temperature: 120~150°C
Shore Harness: 85-09D
Layer Height: 0.03~0.5mm
Shrinkage of Volume: 3.72~4.24%
Cure by UV Wavelength: 355~405nm
Viscosity: 350~550mPA.s @25°C
Compressive Strength: 80-90MPa
Compatible with ALL LCD based 3D Printer:
Creality LD & Halot Series, Anycubic Photon Series, Elegoo Mars Series, Phrozen, Sparkmaker, Wanhao Duplicator D7 etc.

How to use
– Please shake well before use
– Recommended temperature 20C – 25C
– Keep your room well-ventilated while printing
– Always wear nitrile gloves to avoid direct skin contact. Do wash it immediately when contacted with resin