[New Arrival] Water Washable 3D Printer Resin LCD UV-Curing Resin 405nm Standard Photopolymer Resin for LCD 3D Printing

Concerned about the cost of post processing your resin prints?
Resina Water Washable Resin is here to removes the need of using IPA to wash your prints post-processing!

The technical data of the resin is much similar with standard rigid resin.

Note: DO NOT pour this down the sink as it will affect aquatic life.

Benefits of using Water Washable Resin:
– Can be clean with either IPA or Water
– Less sticky compared to Alcohol cured Resin
– IPA can be dangerous if smell directly, and water washable has little to no smell!
– Overall you can save operating cost in long run by just using water.

Print with Mono LCD:
Base Exposure: 40~60s
Normal Exposure: 2~3s

Print with RGB LCD:
Base Exposure: 60~100s
Normal Exposure: 6~10s

Specification:
Withstand temperature: 60~80°C
Shore Harness: 90D
Layer Height: 0.03~0.5mm
Shrinkage of Volume: 1.8~2.5%
Cure by UV Wavelength: 355~410nm
Viscosity: 100~200mPA.s @25°C
Compressive Strength: 49-80MPa
Compatible with ALL LCD based 3D Printer:
Creality LD & Halot Series, Anycubic Photon Series, Elegoo Mars Series, Phrozen, Sparkmaker, Wanhao Duplicator D7 etc.

How to dispose
– You can put the contaminated water outdoor & let it vaporize under the sun.
– If you have an empty container of resin, fill it with some isopropyl alcohol to clean the walls of the container, pour it into a clear contained (glass, plastic, plastic bag) and expose it to UV light until the isopropyl alcohol has evaporated and the resin has hardened, and throw it away

How to use
– Please shake well before use
– Recommended temperature 20C – 25C
– Keep your room well-ventilated while printing
– Always wear nitrile gloves to avoid direct skin contact. Do wash it immediately when contacted with resin

How to Storage
– Keep away from children
– Keep resins sealed tightly in the bottles
– Out of direct sunlight or UV and within 15°C – 35°C
– Do not expose resins to heat, flames, sparks or any source of ignition

Tutorial How to Improve Print Quality on Resin Printer:
https://smith3d.com/7-tips-to-improve-your-resin-sla-3d-print-quality-reduce-print-fails/

What’s included:
Resina Water Washable Resin 1kg x1