🔥Ready stock ship within 24 hours from KL Sungai Besi area*
🔥This is a drop in upgrade for Creality Ender 3 / CR 10 Printers (Now that it has dual z axis port) *
The significant upgrades on v2.0 comparing to v1.2 are:
1) Dual Z Axis port
2) Sensorless Homing
3) Added firmware control to fan1 header
For details regarding SKR Mini E3 v2.0, please visit the link below
🔥Applies to Klang Valley buyers only. Whatsapp us @ ZeroOneOne-10800321 if you need urgent same day delivery (eg. Grab) or self pick-up. Buyers will have to bear the delivery cost and set our Sungai Besi office as pick up point. Do check with us before you purchase as we may not be available.
Only select RM0.00 West Malaysia Shipping if you are opting for self pick-up or grab express (or similar)
BTT SKR MINI E3 V2.0 is a customized motherboard for Ender3 printer launched by the 3D printing team of Shenzhen BIGTREE technology co., LTD., which can perfectly replace the motherboard of the original Ender3 printer.
*If you have leveling sensor such as BLTouch/3DTouch, please note that you might need to rewire them to run properly, please refer to the following guide for more information
WARRANTY NOTE (3 months)
– Any manufacturer defects, please contact us immediately upon receiving the board.
– Wear & tear parts are not covered by the warranty (SD Card).
– Due to minimal profit, if any issue user has to bear with the shipping fee.
???? [Variation: STM Chip]
Please dont make trouble í buy so many board.