‘- The main control adopts 32-bit ARM-level Cortex-M3 series with 72MHz main frequency STM32F103RET6 chip;
– Support BIGTREETECH-3.5 inch TFT color touch screen, LCD12864 screen, CR-6 original screen (DIWEN screen);
– Support offline printing and online printing; Reserved dual Z-axis printer; Support onboard SD card printing function;
– Using high-performance MOSFET tube, the heat dissipation effect is better; and using high-performance MOSFET tube, the heat dissipation effect is better;
Compatible with Community Firmware!
Appearance size: 118.6*80mm
Installation size: 105.4*73.6mm
Microprocessor: ARM 32-bit Cortex-M3 CPU
Input voltage: DC12V–24V
TMC2209 onboard
Motor drive interface: X, Y, Z0, Z1, E
Temperature sensor interface: BED, T0
Display screen: BIGTREETECH-3.5 inch TFT, LCD12864, original screen
PC communication interface: Micro USB, easy to plug and unplug, communication baud rate 115200.
Expanded interface function support: detection of material. interruption, continuous operation after power failure, shutdown after finishing, adjustment of strain gauge equality.
Support file format: G-code
Support machine structure: For CREALITY CR-6 SE
With your multimeter in resistance mode:
Check the heater cartridge in the hot-end – it should measure about 16Ω
Check the cabling to the heat-bed – it should measure about 2Ω to 3Ω
Check the thermistor cable – it should not be shorted (less than 2Ω is likely a failed thermistor)
With your multimeter in voltage mode:
Turn the printer on – check the wiring from the power supply. You should measure about 24V. 24.1V is okay, 25V is too high.
Packaging List:
BIGTREETECH SKR CR6 V1.0 x 1
Reviews
There are no reviews yet.